Product Overview
The Dynisco TPT463E-10M-6/18 combines melt-pressure measurement and a removable Type J thermocouple in one assembly. Its nominal 0 to 10,000 psi range is suited to higher-pressure polymer-processing applications where the pressure channel and melt-temperature channel must be obtained from the same process location.
The pressure bridge provides a nominal 3.33 mV/V signal for compatible industrial indicators and controllers. The 6/18 mechanical configuration uses a rigid sensing section and flexible capillary, helping accommodate cabinet position, cable routing and high-temperature extruder geometry.
Main Product Information
| Complete Model | TPT463E-10M-6/18 |
| Pressure Range | 0 to 10,000 psi |
| Pressure Output | 3.33 mV/V nominal |
| Temperature Measurement | Removable Type J thermocouple |
| Process Thread | 1/2-20 UNF |
| Stem Arrangement | Rigid stem with flexible capillary |
| Electrical Connection | Six-pin connector configuration; verify mating connector |
| Maximum Diaphragm Temperature | Up to 400 degrees C, installation dependent |
Pressure and Temperature Channels
The pressure bridge and thermocouple are separate measuring circuits. A replacement must therefore match both the pressure input specification and the thermocouple input of the existing instrument. The thermocouple should not be assumed interchangeable with Type K, RTD or other temperature elements.
Typical Applications
- High-pressure extrusion and melt-pump systems
- Polymer filtration and screen-changer monitoring
- Plastic pipe and profile production
- Compounding and pelletizing machinery
- Die-pressure and melt-temperature measurement
Replacement Checklist
Confirm the complete TPT463E-10M-6/18 designation, 10,000 psi full scale, mechanical lengths, diaphragm condition, process thread, thermocouple type, connector pinout, bridge excitation and receiving instrument. Do not select a replacement only by the TPT463E series name.
Inquiry and Supply Notes
Submit a clear nameplate photograph and the existing pressure-controller model for configuration verification. Documentation, connection details and availability should be reconfirmed with the quotation.
